SiliconDust USA, Inc.Tech/HDRackOperations ManualOctober 2, 2014© SiliconDust USA, Inc. 2011-2014
Filtering by PIDThe TECH3 supports arbitrary hardware PID filtering:Format: hdhomerun_config <id> set /tuner<n>/filter <filter>Exam
Streaming to a target machineSet the target IP address and port number using the set target command:Format: hdhomerun_config <id> set /tuner<
HTTP Streaming (TECH3-6CC-3x2 only)TECH3-6CC-3x2 models can be used to stream via HTTP (unicast only) to VLC or other clients.Format: http://<ip a
Datacast operationTECH3 units support Datacast TCP/IP over OTA broadcast. Datacasting often provides news, weather,traffic, stock market, and other i
Using /sys/bootThe /sys/boot variable allows the TECH3 unit to automatically set variables at startup, allowing you topreserve settings across power o
Setting the channel mapThe channel map is a non-volatile configuration option that is used to set the channel to frequency table, to configure the cha
MulticastTECH3 supports multicast streaming within a network.1) Using HDHomeRun Config GUI or hdhomerun_config choose a desired channel and program nu
Example Boot Script ConfigurationsTuning 2 ATSC channels and streaming to multicast addresses using RTP:/tuner0/channelmap us-bcast/tuner0/channel 31/
HDHomeRun QuickTV (Windows)HDHomeRun QuickTV is a lightweight viewer suitable for playing multicast video from the TECH3. HDHomeRun QuickTV is install
FCC Notice (US TECH models):This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause
HardwareTECH3 (dual tuner)HDRack (8 tuner ATSC/QAM/DVB-T/DVB-C)1. Power/Network2. Tuner3. Power 4. Ethernet5. Coax in (ATSC/QAM/DVB-T/C)HDRack (6 t
PowerAll devices should be used with the included power supply (dual-tuner models) or power cable(HDRack models).EthernetCo
Additional Tools and SoftwareSoftware InstallationThe latest HDHomeRun drivers, code, and firmware can be found on the Silicondust website:http://www.
Using the Command Line Configuration Utility (hdhomerun_config)Open a command prompt or terminal window and change directory to the HDHomeRun installa
Supported CommandsThe get/set options supported by a specific device can be queried using the get help command: hdhomerun_config <id> get
Channel scanTo run a channel scan:Format: hdhomerun_config <id> scan /tuner<n> [log filename]Example: hdhomerun_config FFFFFFFF scan /tun
Checking the signal strengthThe basic signal information can be obtained by using the get status command:Format: hdhomerun_config <id> get /tun
○ stop = reason for stopping the streamThe counters are reset to zero upon a channel change, but may indicate a small number of errors causedbefore th
Comentarios a estos manuales